Introduction
I advise within special model testing projectsI design multicomponent force balancesI analyze the multicomponent calibration into a matrix calibration.
Expertise areas
Publications
Magazine
Fin propulsion revival
30 Jun 2025
Fin propulsion is experiencing a revival due to its high propulsive efficiency. In early 2025, MARIN successfully tested a new fully electric system ...
Paper
Wind turbine load monitoring during model-test in a wave basin
11 Jun 2023
For the testing of floating wind turbines in a wave basin, several methods have been developed to include the wind turbine loads acting on the ...
Magazine
6-component propeller blade/shaft balance provides important insight
17 Aug 2017
Reading time 6 minutes
MARIN designed a podded propulsor model with an internal motor and rotating 6-component force and moment shaft balance.
Paper
Propeller-ice Impacts Measurements with a Six-component Blade Load Sensor
1 Jun 2013
The impact of ice on a propeller is a complex process, which most likely results into a milling or crushing process, or a combination of both. The ...
Paper
Development of a Six-component Blade Load Measurement Test Setup for Propeller-Ice Impact
1 Jul 2012
The impact of ice on a propeller is a complex process, which most likely results into a milling or crushing process, or a combination. The highly ...
